Introduction to the construction method of using wood grain decorative film for office cabinets - PVC film experience

Introduction to the construction method of using wood grain decorative film for office cabinets - PVC film experience

2021-08-20 / Source: Wood Grain Melamine Paper / 161

More and more tooling projects exist on-site custom cabinet furniture, how to use decorative film products to change the color of it without painting. We take office wall cabinet film as an example to explain the experience of special-shaped PVC film.
How to use decorative film products to change the color of the cabinets customized on site. This construction is actually very simple, we only need more cabinet design effect for cutting construction. Here are some experience points to share with you:

1. The whole film, do not splicing
Here it is said not to splicing, everyone needs to pay attention. It is not that it cannot be spliced, but it cannot be spliced ​​unless it is necessary. For example, the side risers of the cabinet in the picture above, these must be constructed using the entire film. Otherwise, there are too many vertical seams, and it will be ugly.

2. The order of internal filming should be in sequence
When filming the inside of the cabinet, first paste it up and down, left and right, and finally paste the back panel film. On the inner right-angle edge, you must use a thinner scraper to press it out at the right angle, and cut off the excess leftover material, so that the effect will be good after the film is applied.

3. The triangular closure should be meticulous
It must be cut in place at the triangular closing position, so that the effect after the decorative film is angular and the effect is more prominent.