If there is a row switch on the wall, why not remove the protective cover and stick a complete wood grain film

There is a row switch on the wall, how can I not remove the protective cover and stick a complete wood grain melamine paper

2022-06-14 / Source: Modern Wood Grain Melamine Paper / 286

The row switch is often found on the entrance wall of home decoration. People can turn on the lights in all rooms as soon as they get home, and quickly experience the warmth and comfort of the home. However, when the power supply is connected, choose to use a whole piece of wood grain melamine paper. It is also difficult to change the color of the wall. If you don't remove the switch, there are two ways to apply wood grain melamine paper in this area:
Empty the middle part, and then fill it with the remaining wood grain melamine paper after the upper and lower planes are pasted. Scratch in advance on the vacant position and put the switch through. The effect of the lap joint will be seen at the seam to some extent, which is not good-looking, so the customer chose the second one.


If it is a single socket or switch box, it is easy to cut, but for a row like this, it is necessary to consider the spacing of cutting. Then the method is as follows:
First of all, the whole piece of wood grain melamine paper is used, and it is pasted from top to bottom. Paste it on the switch, and determine the approximate position along the edge. Draw a line along one of the diagonals, making sure that the longest section can be passed through. Pass the switch plate diagonally through. After compacting the surrounding wood grain melamine paper, trim off the excess along the edges. And so on for other switches. Finally, put the switch board back again, the complete protection board can press the cut part of the wood grain melamine paper, and the whole will be more beautiful.