How to use decorative film to refurbish and change the color of furniture - PVC film method

How to use decorative film to refurbish and change the color of furniture - PVC film method

2021-08-24 / Source: Wood Grain Melamine Paper / 162

We encounter all kinds of old furniture in life, if we refurbish them with decorative film products, they will look brand new. Today, I will explain to you how to use wood grain decorative film to refurbish old furniture. The renovation and construction method of ordinary flat-shaped old furniture is relatively simple, and it is only necessary to consider the daily usage habits when applying the film. When using decorative film to refurbish, pay attention to the details of the closing and it can be easily done. Today, I will tell you how to refurbish more complicated furniture with more modeling lines through film.

The picture above is a Chinese-style furniture with a special shape. From observation, we can see that there are concave and convex lines on the side of the table, as well as stepped interfaces. There are arcs and lines in the middle and lower half. The specific methods are as follows:
1. Top film
First, start with the film on the top, and close it at the position of the concave-convex line on the four corners of the table. This closure needs to be hot-blown and compacted on one side, and then laminated with the other side, and then hot-pressed with a hot air blower. We stick the short side first, and then stick the long side, so that the problem of curling is not easy to occur in the later use.
Second, the middle bump line film
In the middle position, we try to use the whole film for construction, and try to use a film for the middle convex line, which is heat-blown and shaped. Because the wood grain melamine paper has good stretchability, this type is not too large, and it can be directly hot-blown and then stretched and shaped. When closing the inner corner of the bottom, do not cut it as a whole, you need to reserve a 1-2 mm edge, so that when the bottom film is attached, it will be connected to the upper part, and there will be no problem of bottom exposure.
Third, the side film
Through the case in the picture, we can find that the height of the table is different. Generally, the old master can use the whole film to carry out the film construction. The novice can stick the lower position first. When the film is high, the closing must be arc. The inner corner position, so the construction is faster.


Remarks, when using decorative film to refurbish old furniture, you need to pay attention to several important details. First, if the old furniture has damaged potholes, it must be repaired and smoothed before film construction. The second is: After sticking the film, be sure to use a tool to compress it at the closing position, so that it is more firm and stable.