How to paste wood grain paper on the door in the construction of wood grain film in Heilongjiang Province

How to paste wood grain paper on the door in the construction of wood grain melamine paper in Heilongjiang Province

2022-04-11 / Source: Wood Grain Melamine Paper / 274

Renovation is expensive? Choosing the right method can save you a lot of money on soft outfits. Is it expensive to replace the door? The direct cover sheet can be used again. A really good material is one that can meet the user's requirements in terms of cost, quality and aesthetics. Wood grain melamine paper is one of them.

Let’s take a look at a case together: the renovation and modeling of old wooden doors.

Existing problems:

1. The white door panel does not match the atmosphere of the surrounding office area. The panels around the door are relatively rough and the overall look is not harmonious.

2. The wood grain melamine paper is used for the door and the back panel of the same color, so the lines need to be aligned, otherwise it will look awkward.

3. The top of the back panel is in contact with the ceiling, and it is troublesome to close the mouth.

construction process:

1. The treatment of the base layer is the most important part of the wood grain melamine paper. First, polish the surface smooth, and fill in the sunken pits or nail holes with oily putty.

2. After the putty is dried, there will be excess parts, which also need to be sanded with sandpaper. After all the sanding is done, you can apply the primer, which will increase the viscosity and the surface will be smoother.

3. After drying, you can stick the film. It is best to remove the door lock and hinge before applying the film, so that the construction will be more convenient.

4. It should be noted that the film on the top of the door and on the door panel is a continuous piece, and the texture of the sticker will be consistent with the above, which will look more beautiful. There should be no obvious cutting marks in the contact with the ceiling. It needs to be compacted to the gap with a scraper, which not only looks good but also ensures the service life of the film.

5. At the end of the day, it is best to illuminate it with light, so that the existing problems can be found more clearly, such as blistering and curling, and then dealt with in time.