How to paste imitation marble paper?

How to paste imitation marble paper? Marble paper is a sticker made of imitation marble. It is very cost-effective and easy to use. But if we don't stick the marble paper properly, it will cause it to bubble, mold, and turn up the corners, so how can we stick it well? ​Before sticking the imitation marble paper, ensure that the wall is complete, clean and tidy. When sticking, you need to pay attention to the glue of the marble paper. The glue should be diluted with water slowly, and the glue should be evenly spread on the marble paper, and then left for ten minutes. When sticking it, pay attention to its pattern alignment and stick it to the place with the switch It can be cut off with a utility knife when it is used, and it can be 3-5m longer when it is attached to the top of the wall. It is also easy to adjust if it is not attached properly. After pasting, use a roller to flatten the seam, or use a plastic scraper. If there are small air bubbles, you can use a fine needle to prick it and then squeeze out the air bubbles and then flatten it.