Four major problems that will occur if the treatment of imitation solid wood grain paper and wood grain film is not standardized

Four major problems that will occur if the treatment of imitation solid wood grain paper and wood grain melamine paper is not standardized

2022-03-11 / Source: Wood Grain Melamine Paper / 262

Wood grain melamine paper comes with self-adhesive, which can be used on 90% of our common base layers, but if you don't pay attention to details during the construction process, the following common phenomena will occur. The first is the problem of the base layer. No matter what kind of base layer, the surface needs to be treated to a certain extent. If it is aluminum, iron, glass and other smooth surfaces with wood grain melamine paper, the surface dust needs to be wiped off to keep the surface smooth. If it is a rough surface such as board and gypsum board, there are nail holes or glue marks on it, it should be leveled with putty before the film is applied, and then the surface is smoothed with sandpaper. Brushing the primer can not only increase the wood grain melamine paper The firmness will also clean up the dust to a certain extent. On the surface as shown in the picture, there are many protrusions under the strong illumination of the light, which is the result that the surface is not smoothed, and the visual effect has very large defects.

The second is that the air in the ceiling is not cleaned up or there is no compaction, and the air will infiltrate from a certain place, which will cause the wood grain melamine paper to be glued later, and the middle part will be foamed, so when the film is applied, the details must be Partly dealt with.

The third is the problem of hollowing and air bubbles in the outer corner. This is that when the wood grain melamine paper is pasted, it is not compacted, and it is directly folded to the other side of the outer corner, so it may be glued at the time, but after two days, the hollowing phenomenon shown in the picture will appear.

The fourth is that the inner corner of the door frame is not compacted. When dealing with the inner corner, it is necessary to compact the edge, and then use the scraper to press in the inner corner part, and try to maintain the original architectural shape. As shown in the figure, without compaction, a curved arc will be formed, and there is air between the inner corner and the wood grain melamine paper, which cannot be attached.

Therefore, it is necessary to pay attention to these problems during the acceptance inspection. The pattern of the wood grain may not be clearly seen at a glance, so it is best to turn on the indoor lights during the inspection, so that the problem will be exposed more obviously, and the loss can be stopped in time.