What should I do if the veneer veneer has raw edges?

The veneer veneer can be used on the board, but in the process of use, if there are burrs, it will affect our use.

So it needs to be handled well. First of all, you need to know that the burrs are mainly caused by the saw blade teeth that are worn and not sharp enough, or the saw blade is too large or has flying teeth, and the moisture content of the plate is too low. . For such a situation, we must deal with it in time, otherwise problems will easily occur during use. If the saw blade is worn and not sharp enough, a heavy-set saw blade can be used, the sharp saw blade can be replaced, and the moisture content of the plywood can be checked. Rate. The places with burrs should be trimmed and maintained in time to avoid environmental impact.

Of course, when using it, you should also do a good job of maintenance according to different use environments. Only in this way can you better ensure its use effect and will not cause problems easily.