What are the reasons for the burst edge of melamine veneer paper?

We often experience edge bursts when using melamine veneers, which annoys us, so what is the reason for melamine veneers bursting? How can we prevent it? We together look! 1. When we use the shaft, the shaft may be bent. When it leaves the factory, the manufacturer of the main saw and the slot saw will calibrate it, that is, the two ends are calibrated on a straight line. There may be a problem with the shaft. If there is a problem during use, it is usually because the worker does not understand the direction of the upper and lower saw blades when disassembling the saw blade, or the hexagonal wrench of the main saw is not removed in time when the saw blade is installed, so the shaft is deformed. Of course, this may be Sex is small. 2. The sound when the machine is turned on is normal. When the machine is working for a long time, resonance will occur, and the saw blade will vibrate during operation. We can adjust the contact area with the ground to solve the excessive vibration of the machine. If the saw blade shakes too much, the contact surface between the drive shaft and the machine can be adjusted to transmit the vibration. So when listening to the sound, if the machine is cutting normally, you will not hear the harsh cutting sound. The above are the reasons and preventive measures for the melamine veneer paper that we have summarized for you. I hope it will help you!