Use wood grain decorative film to change the color of irregular Great Wall board shape - PVC film method

Use wood grain decorative film to change the color of irregular Great Wall board shape - PVC film method

2021-08-16 / Source: Wood Grain Melamine Paper / 157

There is a shape effect similar to the concave-convex feeling of the Great Wall board in the design. If we use decorative film to change the color of the film, so as to achieve the effect requirements of the designer. Through a case, I will explain the filming method of the irregular Great Wall board
1. There is an irregular Great Wall board shape as shown in the above picture. When carrying out PVC film construction, we need to pay attention to the problem of the gap between the convex surface and the back of the seam. If the gap is too large and more than 1 mm, it will It must be repaired with putty so that there will be no hollowing problems after construction.

2. After using the wood grain decorative film for construction, it is necessary to check whether the position of the inner corner cutting incision has the problem of exposed bottom. In addition, use a hot air blower to press the closing position after hot blowing, so as to prevent the occurrence of warping in the later stage.

After the film is completed, we need to conduct a second review of the area where the decorative film is used. After the corners are closed and the bubbling unevenness is repaired, it can be completed.

Several points of PVC film:
1. Combined with the construction shape, we use the entire length of wood grain melamine paper for film construction, which requires the cooperation of the upper and lower masters to ensure good positioning.
2. Do not use a width of 1.2 meters to fold, which is difficult to construct, and various problems will occur during construction to increase losses.
3. When sticking the film, it is necessary to pay attention to the right-angle closing at the inner corner, and the cutting must be neat to avoid jaggedness affecting the overall effect.