How to install the imitation marble paper decorative board?

How to install the imitation marble paper decorative board? The imitation marble paper decorative board is not only environmentally friendly and healthy, but also has a good decorative effect. The surface is protected by UV light curing paint, which is wear-resistant, scratch-resistant, pollution-resistant and corrosion-resistant, heat-resistant and cold-resistant, and is very popular among consumers. (1) Installation with wall glue 1. Cover the wall with a base layer, commonly used are 3MM plywood, woodworking board, and the good point is fire-resistant glass magnesium board. Nail them to the wall with air nails and clean the board surface with sandpaper. 2. Saw board, cut the imitation marble decorative board UV decorative board into pieces according to the actual requirements. 3. Chamfering, the four sides of the imitation marble decorative panel to be installed are inverted into a 45-degree angle with an inverting machine. According to the actual installation requirements, some only need to pour the upper and lower sides or three sides. 4. Clean the back of the imitation marble decorative board, and use sandpaper and a rag to clean the back of the UV board. 5. Apply all-purpose glue or woodworking glue evenly on the back of the imitation marble decorative board, then stick the UV decorative board flat on the wall, and then lightly hammer the UV decorative board with your hands to make the UV decorative board stick to the wall more firmly superior. 6. Water-adjustable joint filler, and then fill the joint filler at the intersection of two imitation marble decorative boards at a 45-degree angle, fill it first, and then use the vertical angle of the board to gently cross the intersection from the 45-degree angle, so as to intersect Beautiful everywhere. 7. Clean the surface of the imitation marble decorative board and clean the excess caulking material. (2) Aluminum alloy fixing 1. Cover the wall with a base layer, commonly used are 3MM plywood, woodworking board, the good point is fire-resistant glass magnesium board, and use air nails to nail them to the wall. 2. Nail foot lines on the wall. Use aluminum alloy inner corners to fix the corners, and then use aluminum alloy tool strips to fix the wall corners, that is, respectively nail the aluminum alloy inner corners and the aluminum alloy tool strips to the corresponding positions on the wall. 3. Then there is the sawing of UV decorative panels. Saw the UV board into pieces according to the actual size, and then trim the saw edge with sandpaper to make it smooth and clean. 4. Then insert the UV decorative plate between the aluminum alloy inner corner and the tool strip.